Monthly Archives: May 2016

Dr. Krishnakumar KS – Minor Research Project

Category : Announcements

Congratulations Dr. Krishnakumar K S!!!

Dr. Krishnakumar KS, Assitant Professor, Department of Chemistry and Research Centre, St. Albert’s College(Autonomous), Ernakulam received santion for Research Project entitled “Synthesis of Dinucleotide analogues as Potential antiviral agents” from University Grants Commission (UGC), New Delhi.

Krishnakumar copy

Internship @ ANERT

Category : Announcements


The 1st Batch of B.Voc. Renewable Energy students successfully completed Internship at ANERT (Agency for Non-Conventional Energy & Rural Technology), Department of Power, Government of India at Idukki District Office.
During the period they learned about renewable energy systems and devices including wind electric generator, solar power plants, solar equipment such as lanterns, biogas plants, etc.
Best wishes to the Team !!!

Tender Notice

Category : Announcements

The St. Albert’s College, Ernakulam invites tenders (technical and financial bids in separate envelopes) for supply and installation of following equipments:

Tenders in sealed envelopes along with the EMDs shall reach the Principal at above address on or before 10th June 2016.

4 inch (Length) Bench Frames using 1.5″ 1/8 angle, all legs using 30 x 30 Mm GI tube 18 gauge, rest of the crosses using 25 x 25 mm GI tube 18 guage, top using 12 x 54 inch size 18 mm docuble side laminated edge glue coated green ply brand MDF board All the metals parts in powder coated finish
4 inch Length Desk Frames using 25 x 25 mm square tube 18 guage, “T” shaped legs made with 1.5″ round tube 18 guage with heighted adjustable thread bush rest of the crosses using 25 x 25 mm GI tube 18guage, top using 14 x 54 inch size 18 mm double side laminated edge glue coated green ply brand MDF board all the metal parts in powder coated finish
Network Multi Function Printer

2 nos

(1 with multiple scanning facility)

>=25 ppm , with Security , A6 – A3 paper size , minimum 2GB memory , minimum 320 GB harddisk, USB and SD card support, with continuous printing, Network connectivity, low maintenance cost, duplex mode , Different format print options, Sorting facility
speaker box

6 Nos

15″ + 1″ horn 500 watt RMS plastic speaker cabinet

Type: 2-way bass reflex speaker system
Power handling: 500 watts RMS 900-watt peak
Nominal impedance: 8 Ohms
Components: 1 woofer 15 ” high power coil
1 compression driver 1.4 ” (44mm) exit
Angle of coverage: 90 X 50 degrees
Frequency response: 45~18K (-2dB) 40~20K (-6dB)
Sensitivity: 98 dB
Max SPL: 126 dB Nominal 128 dB Peak
Crossover: Two way passive with protection
Protection: Electronic over voltage on top end
Enclosure: Injection moulded ABS
Connectors: 2 XLN4
Dimensions: 450 X 360 X 690mm
Packing dimensions: 505 X 410 X 755mm

2 Nos

Rated Power Bridge Mode 4 Ohms: 1720 W @ 1 kHz at <0.1% T.H.D.

Rated Power (2 x 8 Ohms): 490 W per channel @ 1 kHz at <0.1% T.H.D. both channels driven

Rated Power (2 x 4 Ohms): 870 W per channel @ 1 kHz at <0.1% T.H.D. both channels

Rated Power (2 x 2 Ohms): 950 W per channel @ 1 kHz at <0.025% T.H.D. both channels driven

Mixer 16 channel

1 nos

16-ch Mixer with 12 x  Mic Preamps, 3 x Aux Busses, 4-band British EQs, Lexicon Effects, dbx Limiters, Switchable hi-Z Inputs, and USB Playback and Recording
Monitor 1 nos 400 watts
Equalizer 1 nos 31 band
Grill 6 nos metal box for the PA system with grill : standard quality
Speaker Cable 2 Core premium quality
Speakon Connectors

And XLR connectors

Mic-cable and Microphone 3 nos





Tender Warranty Certificate

General Terms and Conditions

1 Model and year of introduction of the instrument/ item Shall be mentioned in the tender along with original brochures /catalogue. Though the specifications given are of basic and general in nature, preference will be given for selection of higher- end versions. Therefore, bidders are advised to quote for different models.
2 Place of installation St. Albert’s College, Ernakulam
3 Delivery and installation of equipment: (i)                  The confirmation of acceptance of purchase order by the supplier shall be given within 7(seven) days from the date of issue of purchase order.

(ii)                Delivery and installation to be completed within 3 weeks from the date of opening of L/C.

(iii)               Short shipment and part shipment are not allowed.

4. Price (i) The price shall be quoted in foreign and Indian currencies, indicating break-up for the equipment and accessory instruments, details of import duty/ tax as applicable and other over-heads.

(ii) The price shall be inclusive of all costs of freight, insurance, transportation, delivery (door delivery) and installation & commissioning at the respective laboratory.

(iii) St. Albert’s college reserves the right to accept or reject any offer at its discretion.

5. Mode of payment (i) By Letter of Credit payable in foreign or Indian currency (to be specified):

· 80% of payment on shipment against L/C documents.

· 10% of payment after installation, commissioning and training by the supplier to the satisfaction of St Albert’s college.

· In case of indigenous equipment, 90% of the payment in rupee terms shall be released against satisfactory installation, commissioning and training of the equipment in the respective labs.

· Balance 10% of payment against furnishing of irrevocable bank guarantee by the supplier for equivalent Indian Rupees (issued by a nationalized bank) as performance guarantee for Two years from the date of successful installation and commissioning of the instrument/s.

(ii) In case the supplier cannot provide the bank guarantee as above, the 10% of payment (in equivalent Indian Rupees) shall be retained with St. Albert’s College and released on the expiry of Two after the successful installation and commissioning of the instrument/s.

6. Warranty (i) Two years  from the date of completion of installation for the complete system including replacement of instruments and parts, spares, accessories and labour charges.

(ii) Complete set of spares and consumables as stand by shall be provided/made available along with the equipment or from time to time during the period of warranty.

(iii) The repair/servicing and periodic IPV (Instrument Performance Verification) of the equipment with traceable standards have to be carried out by the manufacturer/supplier free of cost during the entire warranty period, or extended warranty period irrespective of any number of repairs / services.

(iv) Definite time schedule for servicing of equipment, time required for attending break-downs, etc shall be indicated in the terms & conditions for warranty and AMC.

(v) Shall provide good after sale service/technical support capable of attending on short notice at places where the equipment is installed. At least 2 preventive maintenance visits and unlimited breakdown calls by the service/application support engineer during the warranty period, every year.

(vi) The manufacturer / supplier shall give a warranty certificate as per the format attached in the tender Document (Annex I).

7. After sales service (i) Shall provide for annual maintenance contract / after sale service contract after the warranty period.

(ii) The cost/rate and the terms and conditions for AMC and IPV for two years, after the warranty period (4th & 5th years) have to be specified.

(iii) The payment terms for the AMC shall be as per the Rule 159 of GFR 2005(Govt. of India) and amendments there to.

(iv) Definite time schedule for servicing of equipment, time required for attending break-downs, etc shall be indicated in the terms & conditions for AMC.

(v) St Albert’s college  reserves the right to impose penalty @ Rs. 2000/- per day for the delay or other lapses of the manufacturer/supplier/ service provider in rectification of the break-downs beyond 3 working days, during the AMC period.

8. Training of personnel (i) Basic training for a period not less than two weeks after installation of the equipment to our technical personnel of the concerned laboratory.

(ii) Trouble shooting training as and when required.

9. Experience The supplier shall have experience of at least 20 installations and operation of the equipment in India, including the model quoted.
10. Details of EMD 5% of the amount for the total number of equipment (the highest valued model quoted), by way of Demand Draft or Cheque (payable at par) drawn on any of the Nationalized Bank in favour of Principal, St. Albert’s College, Kochi.
11. . Period of validity of the offer/tender90 days.
12. Specification sheets Detailed specification sheet(s) highlighting all the technical and other specifications must be attached
13. Users List Complete list of users in India for the equipment (inclusive of the quoted model) along with certificates/testimonials from the customers shall be enclosed.
14. Cost of tender documents The tender document may be downloaded from St. Albert’s college website and the amount of Rs. 1000/- (Rupees One Thousand only) may be paid towards the tender document fee by Demand draft or Multicity cheque in favour of Principal, St. Albert’s College, Kochi.
15. Last date and time of receipt of tender16.00 hrs on 10. 06. 2016. Tenders received late for any reason whatsoever, shall not be entertained. St. Albert’s College has the right to reject any or all tenders without assigning any reason.
16. Submission of tender The tender shall be duly signed, sealed, super-scribed as “Tender for supply of ……………” and submitted to: St. Albert’s College, Ernakulam, BanerjiRoad, Kochi 682 018, India
17 Installation Check out specification. Shall be provided by the supplier.
The technical presentation on instruments / equipment is to be made at St. Albert’s College , Kochi after opening the technical bids (the date shall be informed later). The price bids (of two bid tender system) shall be opened only after technical evaluation of the technical bids. Those who qualify technically only will be considered for opening of financial bids.

Earnest money deposits (EMD) for the amount of 5% of the price/value (based on total number of equipments quoted) in the form of demand draft / cheque (payable at par) drawn in the name of Principal, St. Albert’s College , Kochi shall be submitted along with the tenders. The firm registered with DGS&D / NSIC as manufacturer for the supply of the same category of item for which the party is submitting quotation will be exempted from submission of EMD. Exempted parties will have to give proof of registration along with their quotation. EMD of the unsuccessful bidders shall be refunded at the earliest but latest within 30 days after finalization of the purchase of concerned item.

The Principal, St. Albert’s College reserves the right to reject the bids or to cancel/postpone the procurement without assigning any reason whatsoever.

“Read More”

International Federation of Catholic Universities

Category : Announcements

With International Federation of Catholic Universities delegates – St. Albert’s College (Autonomous) to new heights…

Rev. Fr. Antony Arackal and Rev. Fr. Christy David Pathiala with Archbishop Andrews Thazhath of Thrissur, Msgr. Guy-Réal Thiverge and Rev. Fr. Deputy Secretary of IFCU


International Collaborations

Category : Announcements

Round Table Conference with the delegates of Foreign University for an International Collaboration


2 3



St. Albert’s College is now Autonomous….

Category : Announcements

Happy News!!!
UGC has granted Autonomous status to St. Albert’s College as an instrument for promoting academic excellence and Mahatma Gandhi University endorse the same on today.

St. Albert’s College is now an Autonomous Institution !!!11535926_559276540876950_2067255277816832644_n

An interview with Dr. Rajagopala Nair

Category : Announcements

An interview with Dr. Rajagopala Nair, Director Albertian Institute of Management (AIM – in today’s business daily.



Rev. Fr. Antony Arackal elected as the National Executive Member of Xavier Board in India and President, Kerala North Region.

Category : Announcements

?Rev. Fr. Antony Arackal elected as the National Executive Member of Xavier Board in India and President, Kerala North Region.
22nd National Triennial Conference of Xavier Board in India with the theme ”Challenges and Prospectus in Higher Education : Opportunities for innovation & Networking” held from
May 5th – 8th, 2016 at Kodakara, Thrissur elected Rev. Fr. Antony Arackal as the President of Kerala Region and as the National Executive Member of Xavier Board in India. Xavier Board in India is the association of Catholic Institutions in India.
Congratulations Rev. Fr. Antony Arackal.10882254_486355801502358_3744782873550166318_n

Team St. Albert’s -Runners Up -May Day Cup Cricket Tournament

Category : Announcements

Kerala State Cricket Team Coach Shri. Balanchandran, Dr. Sajeev Jose, Sri. Anty T J, Sri. Bernard K A, Sri. Shine Antony with the Team St. Albert’s College who became the runners up of May Day Cup Cricket Tournament organised by Department of Physical Education.

Runners Up1



May 2016
« Apr   Jun »